Browsing publications of the research group drug delivery ([HIPS] DDEL) by Authors
Development of artemether-loaded nanostructured lipid carrier (NLC) formulation for topical application.Nnamani, Petra O; Hansen, Steffi; Windbergs, Maike; Lehr, Claus-Michael (2014-12-30)NLC topical formulation as an alternative to oral and parenteral (IM) delivery of artemether (ART), a poorly water-soluble drug was designed. A Phospholipon 85G-modified Gelucire 43/01 based NLC formulation containing 75% Transcutol was chosen from DSC studies and loaded with gradient concentration of ART (100-750mg). ART-loaded NLCs were stable (-22 to -40mV), polydispersed (0.4-0.7) with d90 size distribution range of 247-530nm without microparticles up to one month of storage. The encapsulation efficiency (EE%) for ART in the NLC was concentration independent as 250mg of ART loading achieved ∼61%. DSC confirmed molecular dispersion of ART due to low matrix crystallinity (0.028J/g). Ex vivo study showed detectable ART amounts after 20h which gradually increased over 48h achieving ∼26% cumulative amount permeated irrespective of the applied dose. This proves that ART permeates excised human epidermis, where the current formulation served as a reservoir to gradually control drug release over an extended period of time. Full thickness skin study therefore may confirm if this is a positive signal to hope for a topical delivery system of ART.
Formulation and evaluation of transdermal nanogel for delivery of artemether.Nnamani, Petra O; Ugwu, Agatha A; Nnadi, Ogechukwu H; Kenechukwu, Franklin C; Ofokansi, Kenneth C; Attama, Anthony A; Lehr, Claus-Michael; HIPS, Helmholtz-Institut für Pharmazeutische Forschung Saarland, Universitätscampus E8.1 66123 Saarbrücken, Germany. (Springer, 2021-03-19)rtemether (ART) is second to artesunate in being the most widely used derivatives of artemisinin in combination therapy of malaria. Nanostructured lipid carrier (NLC) formulations were prepared following our previous report using optimized ART concentration of 0.25 g dissolved in 5% w/v mixture of solid (Gelucire 43/01 and Phospholipon 85G) and liquid (Transcutol) lipids at 90 °C. An aqueous surfactant phase at 90 °C was added (dropwise) under magnetic stirring (1000 rpm) for 5 min. The pre-emulsion was speedily homogenized at 28,000 rpm for 15 min and further probe sonicated at 60% amplitude (15 min). Resultant sample was cooled at room temperature and frozen at - 80 °C prior to lyophilization. The freeze-dried sample was used for solid-state characterization as well as in the formulation of transdermal nanogels using three polymers (Carbopol 971P, Poloxamer 407, and Prosopis africana peel powder) to embed the ART-NLC, using ethanol as a penetration enhancer. Transdermal ART-nanogels were characterized accordingly (physical examination, pH, drug content, rheology, spreadability, stability, particle size and morphology, skin irritation, in vitro and ex vivo skin permeation, and analysis of permeation data), P < 0.05. Results indicated that ART nanogels showed good encapsulation, drug release, pH-dependent swelling, stability, and tolerability. Overall, ART nanogels prepared from Poloxamer 407 showed the most desirable drug permeation, pH, swellability, spreadability, viscosity, and transdermal antiplasmodial properties superior to PAPP-ANG > C971P-ANG. A two-patch/week concurrent application of the studied nanogels could offer 100% cure of malaria as a lower-dose (50 mg ART) patient-friendly regimen devoid of the drug's many side effects.